How do you make a bolt and nut in autocad?

Contents

How do you make a bolt in AutoCAD?

Tutorial: Draw a 3D threaded bolt

1. Start a new drawing using acad3d. …
2. Type plan to see the view from the top.
3. Create a new layer, object, and make it blue.
4. Start the POLYLINE command, specify a start point anywhere in the middle of the screen, and draw segments as follows: …
5. Start the REVOLVE command and select the polyline.

How do you make a hex nut in AutoCAD?

Tutorial – Making a Hex Nut in AutoCAD 2004?

2. Make a Polygon using polygon command with 6 side center at 0,0 circumscribed in a circle of radius 36mm.
3. Make a circle at origin of radius 20mm.
4. Use region command and select all and then press enter. …
5. Views>>3D Views>SE Isometric.

How do you add a bolt and nut in Solidworks?

To add nuts and washers at the end of a bolt:

1. Under Series Components, select a component in Add to Bottom Stack. The component is added to Bottom Stack .
2. Select more components as needed. Add washers first, and the nut last. The hardware appears in order from the bolted surface toward the end of the bolt.

How do you draw a bolt?

Here are step-by-step instructions for drawing bolts and nuts for exploded assemblies.

1. Make a circle from the rightmost node point to the one just to the left of it.
2. Draw a line from the center point down to the quadrant point of the circle.
3. Use grips to move the end point up to the middle.

To Specify the Thread Style for Drawing Views

1. Click Layout tab Styles and Standards panel Dialog box launcher. Find.
2. In the Drafting Standards dialog box, in the Thread style section, click the desired thread style.

How do you make a hex nut?

How to Draw a Hex Nut

1. Set your compass to a radius of at least two inches. …
2. Position your compass’ sharp point on any point on the circle’s circumference. …
3. Position your compass’ sharp point at the intersection you just made. …
4. Do Step 3 repeatedly to make a total of six arcs that intersect with the circle’s circumference.

How do you make a hexagonal nut in AutoCAD 2d?

specify center of the circle at center of the polygon. Type 0,0 [Enter]. Specify radius of the circle to 0.125. Type 0.125 [Enter].

How to draw hexagon bolt

1. Open a new drawing. …
2. Make sure Ortho mode is OFF, (it ON when it glow in blue, OFF in grey)
3. Type z [Space bar], type e [Space bar].

How do you add a bolt in Solidworks?

You can add fasteners to an assembly as a configuration of an existing part or as a copy of an existing part. For information about configuring Toolbox, see Configuring Toolbox. Enable the SOLIDWORKS Toolbox Library to use Smart Fasteners: Click Tools > Add-ins.